_________________________________________________________________________________
_________________________________________________________________________________
Universal Network Terminal TAU-32M.IP 47
PPTP Settings:
–
PPTP server
– PPPT server IP address;
–
Username
– username for PPP server authentication;
–
Password
– password for PPP server authentication;
–
VLAN
– when checked, use separate VLAN for PPTP access;
–
VLAN ID
– VLAN identifier;
–
Get GW via PPP
– when checked, use default gateway obtained via PPP;
–
MTU
– maximum packet size that could be transferred through PPP interface without fragmentation;
–
MRU
– maximum packet size that could be received through PPP interface without fragmentation;
–
LCP echo interval (s)
– period of request transmission for LCP echo PPP connection control;
–
LCP echo failure count
– permissible amount of errors connected with LCP echo requests transmission. In
case this amount of LCP echo queries weren't answered, PPP connection will be terminated.
If the network is managed through PPTP, do not click the
Submit Changes
button after you finish
PPTP connection configuration as it may lead to connection loss. Go to
'VLAN conf'
tab first, set the
setting for 'signalling/control traffic transmission via РРTP', and then apply configuration changes
using the
Submit Changes
button.
LLDP Settings:
–
Enable LLDP
– when checked, enable LLDP protocol;
–
LLDP transmit period
– LLDP message transmission period. Default value: 30 second.
To apply changes, click the
Submit Changes
button. To discard all changes made to configuration, click the
Undo All Changes
button.
To store changes to non-volatile memory of the device, click the
Save
button.
5.1.1.2
The “IPSec settings” submenu
In this submenu, you may configure IPSec encryption (IP Security). IPSec is a set of protocols used for
protection of data transmitted via Internet Protocol that enables authentication, integrity check and/or encryption
of IP packets. IPsec also includes secure Internet Key Exchange protocols.
If the network is managed through PPPoE, do not click the
Submit Changes
button after you finish
PPPoE connection configuration as it may lead to connection loss. Go to
'VLAN conf'
tab first, set
the setting for 'RTP/signalling/control traffic transmission via РРРоЕ', and then apply configuration
changes using the
Submit Changes
button.