_________________________________________________________________________________
_________________________________________________________________________________
280
Universal Network Terminal TAU-32M.IP
pstn_200_at_answer
line activity detection
0 – take no action
1 – Release – detect the polarity
reversal as a hang-up signal (BYE
request is transmitted via SIP);
2 – Answer – detect the reverse
polarity as a response signal (200 OK
response is transmitted via SIP)
3 – Ringback tone detection Send
response
after
pstn_rb_detect_timeout timeout
4 – voice activity detection
cpc_rus
subscriber category, when this setting is
enabled, the category will be sent in 'from'
field, and 'tel uri' will be used instead of 'sip
uri';
0 – do not use the category
1-10 – subscriber category
stop_dial
‘#’ button operation
0—recognize '#' as DTMF tone
1—use '#' to end the dialling
modifier
Modifier group used by this profile
0-15
pstn_rb_detect_timeout
RB signal detection time in the subscriber
line. It is used in order not to establish a
conversational connection in the IP network
until the subscriber answers, or until a
certain number of transmissions is detected.
If there is no RB signal during the set value, it
is considered that a response has occurred
(200 OK response is transmitted via SIP), s
1-60
fxo_detect_line_presence
detection of subscriber line connection to
FXO kit to display line status in monitoring
0 – disable
1 – enable
fxo_block_line_presence
blocking of the FXO kit if the subscriber line is
not connected to it
0 – disable
1 – enable
dscp
Type
of
service
for
RTP
packets
(for utilized values, see Table 8)
0 - 255
agc_spk_enable
Rx AGC
0 – disable
1 – enable
agc_mic_enable
Tx AGC
0 – disable
1 – enable
agc_spk_level
Rx adjustment level, dB
-1,-4,-7,-10,-13,-16,-19,-22,-25
agc_mic_level
Tx adjustment level, dB
-1,-4,-7,-10,-13,-16,-19,-22,-25
port_0..31 – individual port 0..31 settings
Enumeration of subscriber ports, used in a file, is less by 1 than enumeration, used in web interface and on
the device housing!
Example, port_0 in file correspond to port 1 in WEB interface and device case.
phone
Subscriber number
String, 50 characters max.
or ''—parameter is not defined
user_name
subscriber name
String, 50 characters max.
or ''—parameter is not defined
auth_name
User name used for authentication
String, 50 characters max.
or ''—parameter is not defined
auth_pass
Authentication password
String, 50 characters max.
or ''—parameter is not defined
hotnumber
number that will receive the call when
'Hotline/warmline' is enabled;
String, 20 characters max.
or ''—parameter is not defined
tdmhotnumber
number to which the call is made when using
the 'warm line' service in the direction from
IP to telephone line
String, 30 characters max.
or ''—parameter is not defined
category
SS category
0-255