_________________________________________________________________________________
_________________________________________________________________________________
282
Universal Network Terminal TAU-32M.IP
FXO.
fxo_delay_dialing
dialing delay if the detection of the 'Station
Response' signal is not used
0-10
dt_detect_time
Dial tone time detect (s)
2 - 60
enable_cpc
use a short-time break of the subscriber loop
on clearback from the opposite subscriber's
side
0 – disable
1 – enable
cpc_time
Duration of a short-time break of the
subscriber loop, ms
200-600 ms
transmit_number
transmit the complete number received from
IP (from Request URI header of INVITE
request) into the line, including FXO unit
subscriber number
0 – disable
1 – enable
dont_transmit_prefix
transmit the complete number received from
IP (from Request URI header of INVITE
request) into the line, excluding FXO unit
subscriber number
0 – disable
1 – enable
pstn_200_at_answer
polarity reversal detection action
0 – take no action
1 – Release – detect the polarity
reversal as a hang-up signal (BYE
request is transmitted via SIP);
2 – Answer – detect the reverse
polarity as a response signal (200 OK
response is transmitted via SIP)
3 – Ringback tone detection Send
response
after
pstn_rb_detect_timeout timeout
4 – voice activity detection
fxo_call_busy
503 service unavailable on busy (sip)
1 – when the subscriber line is busy
(FXO), a reply 503 will be sent via SIP
0 – when the subscriber line is busy
(FXO), a 486 response will be sent via
SIP.
dialing
line dialing type
pulse
DTMF
min_level_detect
minimum level of detected signals, dBm
20-40
dial_tone_detect
dial tone detection parameters
X;Z(A/B/1) or X;Z(A/B/1);nc
X,Y;Z(A/B/1) or X,Y;Z(A/B/1);nc
X,Y;Z(A/B/1+2) or X,Y;Z(A/B/1+2);nc
X,Y;Z(A/B/2) or X,Y;Z(A/B/2);nc
For more information see Section
5.1.2.4
busy_tone_detect
busy tone detection parameters
disconnect_tone_detect
disconnect tone detection parameters
hotline
'Hotline/warmline' service
0 – disable
1 – enable
port_profile_id
Subscriber profile number
0-7
profile_id
SIP profile number
0-7
hottimeout
Delay timeout in seconds for the start of the
automatic dialling when the 'Warmline'
service is enabled.
0-300
tdmhotline
'warm line' service, which works in the
direction from IP to telephone line
0 – disable
1 – enable
tdmhottimeout
time delay in seconds before automatic
dialing when using the 'warm line' service,
which works in the direction from IP to
telephone line
0-300
no_offhook_at_ringing
do not close the loop when calling from TDM 0 – disable (short)