_________________________________________________________________________________
_________________________________________________________________________________
156
Universal Network Terminal TAU-32M.IP
–
Last registration at
–last known successful registration on SIP server;
–
Next registration after
–remaining time for SIP server registration renewal;
–
H.323 GK
– H.323 gatekeeper registration time;
–
Test–
testing parameters of a subscriber line corresponding to this port;
–
FXS statistic
– request statistics of voice traffic transmission for this port.
Information about the blocking
If port was in
'blocked'
state, then
'Last block cause'
link will be active (reason and time of the last known port
blocking):
–
leakadge current has exceeded the permissible parameters –
leakage
current block;
–
temperature current has exceeded the permissible parameters–
temperature block;
–
power dissipation has exceeded the permissible parameters –
power dissipation block;
–
reinitialization by changing the input voltage
– port reinitialization due to input voltage fluctuations;
–
hardware reset
– hardware reset;
–
low Vbat level
– low input voltage level;
–
FXS port out of order
– port is out of order/faulty;
–
Receiver offhook
– offhook block. If the subscriber's phone is offhook, and the
'busy'
tone is played, after
the expiry of two-minute interval the
'Receiver offhook'
tone will be played to the subscriber's phone, and
the port will switch into the blocked state.
If the port is already in
'blocked'
state, and the
'Last block cause'
link is inactive, it means that the port was
blocked when the phone is offhook. This blocking will be performed after the 'busy' tone is played to the subscriber's
phone for two minutes. Upon the expiry of two-minute interval, a loud triple-tone will be played to the subscriber's
phone notifying them that the phone is offhook.
To save the changes you must click the
Save button.
When you click on the
Hide blocking
info button
information on blocking will be removed. When you click the
Hide all
button the results of tests of all types will be
removed.
Port test
The
Run test
button, located against each port, allows to test the subscriber line associated with this port.
Click this button to begin test (test continues about 1 minutes). To see the results when the test finishes, hover the
mouse cursor over the
'result'
link located against the respective port, or open the test results window by clicking
the link: