26
36" GAS RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed exactly, a fire or explosion may result causing
property damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appli-
ance.
— WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
— Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Dimensions and Clearance
Provide adequate clearance between range
and adjacent combustible surfaces.
TYPICAL CONTROL PANEL
X.
HEIGHT
HI
Profile Control Panel
45 5/8" min.
LO
Profile Control Panel
40 7/8" Min.
Figure 1
35 15/16”
X
25 1/8”
36” +/- 1/8”
45 3/8”
Door open
36”
36 1/4”
36”
18”
2”
30” Minimum
Minimum to
wall on either
side of range
above 36”
height
Between Cabinets
Minimum to cabinets
on either side of
range
0” Clearance at rear of
range below cooktop
Summary of Contents for 30" GAS FREESTANDING RANGES
