MANUAL ELDES ESIM264 V3.2
MANUAL ELDES ESIM264 V3.2
EKB3
Enter parameter 25, event number and parameter status value:
25 01 1 #
- General alarm
25 02 1 #
- System armed
25 03 1 #
- System disarmed
25 04 1 #
- Mains power loss
25 05 1 #
- Mains power restore
25 06 1 #
- Low battery
25 07 1 #
- Battery failed
25 08 1 #
- Periodical info
25 10 1 #
- Tamper alarm
25 11 1 #
- System started
25 12 1 #
- Wireless signal loss
25 13 1 #
- System shutdown
25 14 1 #
- Temperature fallen
25 15 1 #
- Temperature exceeded
Example:
25061#
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
27.1. SMSC (Short Message Service Center) Phone Number
An SMS center (SMSC) is a GSM network element, which routes SMS text messages to the destination user and stores the SMS text message
if the recipient is unavailable. Typically, the phone number of the SMS center is already stored in the SIM card provided by the GSM operator.
If the user fails to receive replies from the system, the SMS center phone number, provided by the GSM operator, must be set manually.
Set SMSC phone
number
SMS
SMS text message content:
ssttteeellnnuumm
Value:
ssss
– 4-digit SMS password;
ttteeellnnuumm
– up to 15 digits SMSC phone number.
Example:
114417031111111
ATTENTION:
Before setting the SMSC phone number, please check the credit balance of the system’s SIM card. The system will fail to reply
if the credit balance is insufficient.
28. EVENT LOG
This feature allows to chronologically register up to 500 timestamped records regarding the following system events:
• System start.
• System arming/disarming.
• Zone violated/restored.
• Tamper violated/restored.
• Zone bypassing.
• Wireless device management.
• Temperature deviation by MIN and MAX boundaries.
• System faults.
The event log is of LIFO (last in, first out) type that allows the system to automatically replace the oldest records with the the latest ones.
View event log
EKB2
Menu path:
OK
→
VIEW EVENT LOG
→
OK
→
uuuu
→
OK
Value
:
uuuu
- 4-digit user code.
To export the event log to .log file or clear it, please refer to the following configuration method.
Export/clear event log
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
By default, event log is enabled. To disable/enable this feature, please refer to the following configuration methods.
Disable event log
EKB2
Menu path:
OK
→
CONFIGURATION
→
OK
→
aaaa
→
OK
→
PRIMARY SETTINGS
→
OK
→
EVENT LOG
→
OK
→
DISABLE
→
OK
EKB3
Enter parameter 36 and parameter status value:
36 0 #
Example:
360#
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
Enable event log
EKB2
Menu path:
OK
→
CONFIGURATION
→
OK
→
aaaa
→
OK
→
PRIMARY SETTINGS
→
OK
→
EVENT LOG
→
OK
→
ENABLE
→
OK
EKB3
Enter parameter 36 and parameter status value:
36 1 #
Example:
361#
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
