EKOM invent DK50 DI, User Manual

Page: 6 / 148

GENERAL INFORMATION
6 NP-DK50 DI-15_08-2020
- The equipment is used in accordance with this manual.

This manual accurately describes the design of the compressor and its
compliance with safety and technical standards. The manufacturer
reserves all rights to its wiring diagrams, procedures and names.

This user manual is the original instructions. Translation is performed in
accordance with the best available knowledge.
General safety warnings
The equipment is designed to operate safely when used correctly. Please
note the following safety measures to avoid injury or damage.

Equipment operation must comply with all local codes and regulations.

Original packaging should be kept for the possible return of the unit. Only
original packaging ensures optimal protection of the equipment during
transport. If it is necessary to return the equipment during the warranty
period, the manufacturer is not liable for damages caused by incorrect
packaging.

The user must immediately notify the supplier if any problem occurs during
the use of the equipment.

This product is not intended for use in areas where there is a risk of an
explosion. Do not operate the compressor in the presence of flammable
anaesthetics.

Never feed oxygen or nitrous oxide into the compressor. Compressor
components are not approved for oxygen or nitrous oxide use.

The compressor must not be used for supplying air to the medical air
central distribution pipeline system.
Electrical system safety warnings

To avoid the risk of electric shock, this equipment must only be connected
to a supply mains with protective earth.

Before the compressor is plugged in, make sure that the voltage and
frequency of the mains specified on the equipment are the same as the
power mains.

Before operating, check for possible damage to the equipment and any
connections. Damaged pneumatic and electrical lines must be replaced
immediately.

If a technical failure occurs, immediately disconnect the equipment from
the mains (pull out the main power plug).

During repairs and maintenance, ensure that:
- The main power plug is removed from the power socket
- Compressed air lines are disconnected
- All pressure has been released from the air tank

Only a qualified technician can install this equipment.