Efka AB620A5035, Operating Manual

Page: 10 / 104

- AB620A5035
- 10 -
Input of the code number for the fitting level.

Parameter 500 is displayed.

Parameter 290 for functional sequence of the cutting procedures.

Parameter 467 for selection of motor.

Parameter 111 for the maximum speed.

Parameter 161 for direction of motor rotation.

Parameter 270 for type of position sensor.

Parameter 272 for transmission ratio.

Important! The transmission ratio should be determined and
indicated as precisely as possible.
If parameter 270 =0 or 5 , continue with input of 451 .
Check the transmission ratio.

Move pedal forwards. Let the drive run until ready (rdy) is displayed.
Press pedal to position 0. The check is complete.

if parameter 270 = 6 , set the reference position.

Turn hand wheel until symbol o display goes off.

Set reference position (e.g. height of the stitch plate, lower dead point).
Parameter 451 for position 1.

Parameter 453 for position 2.

To repeat the cycle from parameter 290 , push button E.

Or end with button P (2x).

The values can be varied by pressing key +/-.
The input of the code number is described in the general operating manual!