Efka AB620A5035, Operating Manual, Page: 85 / 104

- AB620A5035 Instruction Manual
- 85 -
Parameters Designation Unit Max Min Preset Ind.
155 LSG Mode signal run
0 = Signal Off.
1 = Signal run On.
2 =
Signal “run” enabled when the speed is >3000 RPM.
3 = Signal with pedal <> 0.
4 = Signal enabled only after motor synchronization (one rotation at
positioning speed after power On).
5 = Motor runs Eco with setting F-84 and F-85
6 = Motor runs the same as chain suction at the seam start / end
with counter F-084 and F-085
7 = The same as 6, however chain suction at the start of the seam
can be interrupted and with switch-off start backtack F-156
7 0 1
156 t05 Switch-off start backtack
for the signal “run” or signal with
pedal in pos. 0 (neutral)
ms 2550 0 0
157 SFS Stitches until thread tension release Off after light barrier
covered at the start of the seam (Only in mode 7) Stitches 254 0 0
161 drE Direction of motor rotation
0 = Clockwise rotation
1 = Counterclockwise rotation 1 0 1
162 n2A Start backtack speed whenever the backtack can be
interrupted by pedal in pos. 0 (neutral) (Parameter 164) RPM 9900 200 600
163 n2E End backtack speed whenever the backtack can be
interrupted by pedal in pos. 0 (neutral) (Parameter 164) RPM 9900 200 600
164 StP Start and end backtack can be interrupted by pedal in
pos. 0 (neutral) On/Off 1 0 0
170 Sr1 - See Section Fehler! Verweisquelle konnte nicht
gefunden werden. Setting the reference position
(Parameter 170)
172 Sr3 See Section 6.10 Indication of the setting of the positions
173 Sr4
See Section 8 Signal test
OFF
174 Lng Language selection V860 control panel
1 = English
2 = German
2 1 174 Lng
176 Sr6 Service routine for total operating hours display.
The process is as with display example of parameter 177.
177 Sr7 Service routine for display of hours since the last service.
Display example for the operator control panel:
Press the E key

Display Sr7=
Press the >> key

Display h t
Press the E key

Display 0000
Press the >> key

Display h h
Press the E key

Display 0000
Press the E key

Display Min
Press the E key

Display 00
Press the E key

Display SEc
Press the E key

Display 00
Press the E key

Display MS
Press the E key

Display 000
Press the E key

Display rES
Press the E key again to restart routine, or press the P key twice to
return to operational status
Display example for the V810 control panel:
Press the E key

Display Sr7 [°]
Press the >> key

Display hoUr
Press the E key

Display 000000
Press the E key

Display Min
Press the E key

Display 00
Press the E key

Display SEc
Press the E key

Display 00
Press the E key

Display MSEc
Press the E key

Display 000
Press the E key

Display rES F2
Press the P key twice

Display e.g. Ab620A
Display example for the V820 control panel:
Press the E key

Display F-177 Sr7 [°]
Press the >> key

Display hoUr 000000