Efka AB620A5035, Operating Manual

Page: 48 / 104

- AB620A5035
- 48 -
103 Signal AFF3 switchable as flip-flop: Upon pressing the key, signal AFF3 is activated and deactivated
when pressing the key again, manual lock automatic
104 Manual lock automatic
105 -109 No function
109 Part lift mode 66
110 No function
111 Machine run blockage effective in Pos. 2 at the seam end with closed contact
112 Foot lifting FlipFlop
113
– 117 No function
118 FlipFlop for running at maximum speed
7.27 Software Debouncing of All Inputs
Function with or without control panel Parameters
Software debouncing of all inputs (EnP) 238
238 =0 No debouncing
238 =1 Debouncing
7.28 F1/F2 Function Key Assignment on the V810/V820 Control Panels
Function with control panel Parameters
Selection of input function on the (A) "F1" key on the V810/V820 control panels
Selection of input function on the (B) "F2" key on the V810/V820 control panels (tF1)
(tF2) 293
294
The function of the keys F1 (A) and F2 (B) can be selected on the control panels using parameters
293 and
294 .
293/294 =
0
Input function blocked
1 Needle up/down: Upon pressing the key, the drive runs from position 1 to position 2 or from position 2 to
position 1. If the drive is outside of the stop position, it moves to the preselected home position.
2 Needle up Upon pressing the key, the drive runs from position 1 to position 2.
3 Single stitch (basting stitch): Upon pressing the key, the drive performs one rotation from position 1 to
position 1. If the drive is in position 2, it runs to position 1 upon pressing the key and from position 1 to
position 1 each time the key is pressed again.
4 Full stitch: Upon pressing the key, the drive performs a full rotation depending on the stop position.
5 Needle to position 2: If the drive is outside of position 2, then after pushing the key it moves to position 2.
After the power is switched on, the drive runs until it has synchronized.
6...12 No function
13 High lift for walking foot operational mode not stored:
The signal “high lift for walking foot” is issued as
long as the key is held down, and the drive runs with speed limitation (n10).
14 High lift for walking foot operational mode stored /flip-flop 1:
The signal “high lift for walking foot” is
issued upon briefly pressing the key, and the drive runs with speed limitation (n10). The operation is
disabled upon pressing the key again.
15 Tape cutter or fast scissors (mode 6/7): Upon pressing the key, the tape cutter will be enabled for a
preset time.
16 Intermediate Backtack: Upon pressing the key, the backtack will be enabled anywhere in the seam and at
standstill of the drive.
17 Backtack suppression / recall: Upon pressing the key, the backtack will be suppressed or recalled once.
18 No function
19 Bobbin thread monitor
20...100 No function