72
Scout 320 REV 3:2018
Parameter description: If bar pusher position is over the setting value the
pusher will retreat to setting position when chuck
close. In order to prevent friction and vibration caused
from pusher going into the lathe spindle too far.
Setting method: By manual operation let the bar pusher move into the
spindle inside around 1 / 3 of its length. To ensure not
to touch the spindle and input the current position.
For example: Reference figure 4
:
If the value of parameter is set to
800mm and the bar pusher is out of the A area, the
bar pusher will retract to 800mm after chuck closed.
Note: This parameter is only used for fixed headstock
lathes.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~3000mm
Setting value:
