61
Scout 320 REV 3:2018
Parameter description: During bar change when the bar has been loaded into
the channel the pre-feed pusher will then move the
bar to the first feed position.
Setting method: Input the required speed for feeding speed
parameter.
Note: If the speed of pusher is too fast this may cause bar
material to pass desired first feed position. Lowering
the value will slow done the pre-feed pusher
movement.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~500rpm
Setting value:
Parameter description: The speed of pusher as it enters towards the work
holding area. On a Swiss lathe this is just behind the
guide bushing to the chuck facing position.
Setting method: Input the required speed for feeding into the work
holding area.
Note: Set actual speed to avoid crashing. This only changes
the speed from a predetermined position. The
position of speed change is not adjustable. This
speed is normally slow to keep from over shooting the
desired position.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~500rpm
Setting value:
Parameter description: The speed of the bar pusher pushes out remnant
when receiving bar end signal.
Setting method: Input the required speed.
Note: Set actual speed to avoid crashing. This is only used
when a front eject collet is installed and the process
requires the remnant to be ejected from the lathe
side.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~500mm
Setting value:
