37
Scout 320 REV 3:2018
When changing the channel set it is important to remove then replace one item at a time. If you
get ahead of yourself it may take longer setting up the new channel set. The channels pieces
are directional and may be installed 180 degrees off.
The channel is directional.
Note the flat and angular
points on the channel.
The angle side is on the side
of the carriage.
The short feed pusher screws must be cleaned of any oil and a medium thread lock used. The
screws should be replaced after a few times being removed. The button head screw head can
be stripped easily.
The pre feed pusher flag should be
flat. If the flag is bent it should be
bent back to flat or replaced. The
mounting screws should be clean
and medium strength thread lock be
used.
Note the short end is the material
contact end.
