65
Scout 320 REV 3:2018
Parameter description: In automatic mode setting 1st Anti-Vibration Device
open position. This is the roller/block device inside
the bar feeder nearest the material sensor.
Setting method: In manual mode move pusher collet forward until
30~50mm before 1st anti vibration device. Then input
the current position.
Note: First anti–vibration
should be opened before the collet
arrives to avoid the material separation from the collet
and damaging the rollers/blocks.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~5000mm
Setting value:
Parameter description: In automatic mode during pre-feeding the AVD will
close lifting the bar to center it while loading into the
spindle.
Setting method: Allow bar end to pass through the AVD then input the
required length.
Note: To disable this parameter function, set the value to
zero. The bar end must be through the AVD before
closing or damage to the rollers/blocks will occur.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~5000mm
Setting value:
Parameter description: In Auto-Mode, this parameter is to setup how much
distance to go before the clamping of the AVD closes
again, after passing "First anti-vibration opening
position."
Setting method: Input the required length.
Note: To disable this parameter function, set the value to zero.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~5000mm
Setting value:
