Edge PresencePlus P4, User Manual

Page: 124 / 182

116
P/N 120413
01/05
Teach PresencePLUS ® P4 EDGE
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Teach Screen
Use the Teach screen to automatically set judgment tolerances to accommodate all variations of good product.
-------------------------------------------------------------------------------------
Teach Screen
------------------------------------------------------------------------
After teaching the inspection, typically proceed to the Run screen to run it.
NOTE: Before entering the Run screen, a pop-up prompts the user to save the inspection. Save the inspection to one of the
memory locations on the Sensor.
As an alternative to teaching, enter judgment tolerances in the Results tab in the Test tool, and run the inspection without
teaching. See Test Tool Configuration (in Section 7, Tools ) on page 92.
To display the Teach screen:
Click the Teach button on the Main Menu toolbar, or click the Next button on the Tools screen Build tab.
To exit Teach options:
To go to the Run screen, click the Next button on the Teach Tool tab. To go to another destination, click one of the options in
the Main Menu toolbar.
NOTE: Teach will only widen the minimum and maximum values in the test tools. If some or all values in the test tool(s) are
entered manually, then Teach will only widen these tolerances, if needed, for the taught inspection.