Edge PresencePlus P4, User Manual

Page: 100 / 182

92
P/N 120413
01/05
Test Tool Setup PresencePLUS ® P4 EDGE
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Test Tool Setup
The Test tool is used to set tolerances to the results of the Vision and Analysis tools and to activate the discrete outputs.
Typically, these tolerances are set automatically during Quick Teach or Teach. See
Teaching an Inspection (in Section 9,
Teach ) on page 117. They also can be manually set or modified before or after teaching or running the inspection, in which case
Quick Teach will discard any manually-entered values. For inspections with many Vision tools, the Test tools can be linked
together.
Test Tool Configuration
o
---------------------------------------------------------
Name (default: TT_1, TT_2)
-
Used to rename the tool.
- The name can have only alphanumeric characters or underscores and no spaces.
Logic (default: AND)
Use logic to combine multiple inputs to the Test tool. The results at the
inputs and the logic option selected will determine whether the Test tool is
TRUE or FALSE.
See the following Examples of Logic Results table.
Test tool results can be used as follows:
•
Gather results from image processing tools and discrete
inputs
•
Establish parameters for desired inspection results
•
Tie multiple results together with logic options
•
Include results in the overall Pass/Fail criteria
•
Activate an output based on the inspection results