Edge PresencePlus P4, User Manual

Page: 147 / 182

01/05
P/N 120413
139
User’s Manual System Setup
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Communication Tab
Use the Communication tab to modify the IP address and subnet of the Sensor connected to the PC.
NOTE: An option box to open the Communication tab is automatically displayed if the Sensor either is not connected or is
connected but with the wrong location selected.
-----------------------------------
Modify Sensor IP Address
Communication Tab Sensor IP Address Window
----------------------------------------------------------
To change the Sensor IP Address:
1. Enter the new IP address and click OK .
2. Change the IP address in the Communication tab to the new address.
NOTE: Performing a system reset in Step 3 may result in lost communication if communicating via an Ethernet
connection.
3. Reboot the sensor. Perform a system reset if desired.
4. Restart the software.
5. Change the IP address to the new address in the
Communication tab.
Serial Communication
Serial: This selection will allow the serial channel to be configured. The Baud Rate, Data Bits, Parity, and Stop Bits may be
configured. Currently flow control is NOT selectable.
Click here first...
...then type in the Sensor’s IP Address.