5
en
reMoVIng/InstallIng the VehIcle Body
1. Remove the receiver battery pack cover.
2. Install 4 AA batteries in the battery holder.
Make sure you pay attention to the battery polarity.
AA batteries should have enough voltage to complete the
break-in process; however, we recommend using the 6V receiver
battery pack included in the Dynamite
®
Deluxe Nitro Starter Kit
(DYN2305, sold separately).
cautIon:
Never use rechargeable AA batteries
in the included battery holder. Rechargeable battery voltage
is too low to safely power the radio system and may result
in damage to the product.
3. Install the receiver battery pack cover.
notIce:
If the steering or throttle response slows, stop the
vehicle, turn off the engine, power off the receiver, and replace
the AA batteries or charge the receiver pack (if applicable).
InstallIng the WIng
1. Remove the long wing clip from the wing mounts.
2. Align the holes in the wing with the wing mounts.
3. Press the wing onto the wing mounts.
4. Secure the wing by sliding the long wing clip through
the wing mounts.
InstallIng the receIVer BatterIes
removing
1. Remove the two body clips.
2. Pull off the body.
Instaling
1. Install the body over the two body posts. Take care
while feeding the pull start handle and receiver
antenna through the corrresponding openings.
2. Install the two body clips.
