4
en
1
transmitter
Frequency 2.4GHz
Modulation
DSM, DSM2, Marine
Battery
AA x 4
sPecIfIcatIons
coMPonents
VehIcle PreParatIons
Included Items
1. ECX
™
Revenge Type N
™
1/8-scale Nitro Off-Road Buggy
2. Spektrum
™
DX2E 2.4GHz transmitter
• 3 degree toe set
• Shock spacers
• Air filter assembly
• Turnbuckle wrench
• L wrenches: 1.5, 2 and 2.5mm
needed to complete
• Nitro fuel
• Glow igniter
• 8AA batteries
• Never install damaged batteries.
• Never install batteries of mixed types or of different ages
in the transmitter.
• Always remove exhausted batteries.
• Always remove batteries before storing the transmitter.
• Low battery power can result in loss of control of the RC vehicle.
transMItter Battery safety PrecautIons
1. Slide the panel open on the bottom of the
transmitter.
2. Obey the battery plus (+) and minus (-) diagram
in the transmitter to install 4 AA batteries.
3. Slide the panel closed.
We recommend using only alkaline AA batteries
in the transmitter, however, it is possible to use
rechargeable Ni-MH batteries.
cautIon:
If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
InstallIng transMItter BatterIes
3
1
2
2
POWER
ST. TRIM
TH. TRIM
ST. RATE
steering servo
Power Supply
4.8V~6V (shared with receiver)
Output Torque
199.8 oz-in (8.5 kg-cm)
Operating Speed 0.20 sec/60 degrees of travel
Size
55.6 x 18 x 30mm
throttle servo
Power Supply
4.8V~6V (shared with receiver)
Output Torque
41.66 oz-in (3 kg-cm)
Operating Speed 0.23 sec/60 degrees of travel
Size
55.6 x 18 x 30mm
