ECKELMANN VS 3015 C, Operating Instruction

Page: 106 / 185

14.01.2019 106/185
7 Connection and terminal assignment of VS 3015 C
The illustrations and tables show the terminal assignments for the pack controller and its SIOX extension
modules. A detailed description of the connection and terminal assignment of the controller and its components
is shown below.
7.1 Connector pin assignments
7.1.1 Connector pin assignments for the VS 3015 C basic module
After connection of the power supply, the LIFE LED flashes, see chapter Status LEDs .
The following points must be strictly taken into account for the cabling:
• The system must be disconnected from the power supply before detaching or inserting plug
connectors on the basic module and the SIOX extension modules.
• All connection cables from and to the controller - with the exception of the digital inputs and the
relay outputs - must be shielded. Otherwise malfunctions, e.g. faulty measurements, cannot be
ruled out.
• Pay strict attention to the correct polarity for inputs and outputs with current or voltage interface
((0..10 V or 4..20 mA). Short circuits or a faulty power supply can result in impairments of the
function or even destruction of components of the controller. It must also be strictly ensured that
the inputs / outputs are correctly configured using the jumpers provided for this (current or
voltage interface, see chapter
Konfiguration der analogen Ein- und Ausgänge ).
