14.01.2019
128/185
Exit from the menus and operating screens
Tap the ESC button to exit from menus and operating screens. This returns to the next higher-level menu. All
menus and operating screens are exited automatically 10 minutes after the last time any button was tapped. A
jump to the main menu or to the alarm menu if any error message is pending (only store computer / operator
terminal) is performed here.
9.2.2 Call controller menu using remote operation
CI 4x00 System Centre - Remote control
The terminal for remote control of the controller (menu 2-2 or menu 4-2) is called in the system centre as
follows:
Step 1:
Tap "
2 - System overview
" or
"4 - Configuration
" in the main menu. If "2" is selected, the values
below are only displayed as read-only; for "4", the input lock must be previously deactivated by logging in (see
), so that the settings below can be made.
Step 2:
Tap "
2 Case controllers
" and select the required controller in the list that is then displayed using the
cursor buttons (↑) and (↓). In the screen that opens, the name, position designation and the alarm priority of the
controller can be input as required.
Step 3:
The main menu of the controller is then displayed by tapping the "Remote control" button:
If the system centre, store computer or operator terminal remains locked down, settings on the
controller are read-only. Changes and inputs are not possible.
However, if any parametrisation is required, the input lock must be deactivated, see
.
Tip:
Detailed descriptions for the basic configuration of the controller, name of the controller and its
position designation or about the settings of important parameters can be found in chapter
.
Summary of Contents for VS 3015 C
Page 8: ...14 01 2019 8 185...
Page 46: ...14 01 2019 46 185...
