14.01.2019
12/185
2.1 Exclusion of liability for non-observance
This operating manual contains information about the commissioning, function, operation and maintenance of
the controller and the associated components.
2.2 Requirements for the personnel
Special technical knowledge is required for planning, programming, installation, putting into service and
maintenance work. This work may only be performed by trained or specially trained personnel. The installation,
commissioning and maintenance personnel must have training which authorises interventions in the system
and the automation system. The planning and programming personnel must be familiar with the safety
concepts of automation technology. Specialist knowledge is required for work on electrical systems. Work on
electrical systems may only be carried out by qualified electricians or persons under their guidance or
supervision. In doing so, the respective applicable regulations (e.g. DIN EN 60204, EN 5017
8, BGV A3,
DIN
VDE 0100/0113) must be observed. The operating personnel must be instructed in handling the system /
machine and the controller and must be familiar with the operating instructions.
2.3 Intended Use
This controller has been designed exclusively for the intended use:
The VS 3015 C controller is designed for use as pack controller in commercial and industrial refrigeration
facilities in accordance with the scope of functions and in accordance with the environmental conditions
described in this operating manual.
Note the safety instructions and the instructions for installation and start-up, operation and maintenance. Start
the commissioning and/or operation of the machine / system AFTERWARDS.
The safety and the function of the machine / system are only fulfilled with this intended use.
Never use the machine / system, its components, control components or parts for any other purpose.
The system must not be put into operation until conformity with the applicable EU Directives has been
established for the entire installation.
Work on the electrical system may
only be performed by authorised specialist personnel
(according to the definition for specialists in DIN/VDE 0105 and IEC364, see chapter
'Sicherheits- und Gefahrenhinweisen'
) and in accordance with the respective applicable
•
VDE regulations
•
Local safety regulations
•
Intended use; see chapter
Warning Signs and Symbols Used
•
Five safety rules according to BGV A3, see chapter
•
ESD measures, see chapter
•
Operating instructions
A basic requirement for safe and trouble-free operation is
compliance with this operating manual
.
Summary of Contents for VS 3015 C
Page 8: ...14 01 2019 8 185...
Page 46: ...14 01 2019 46 185...
