ECKELMANN UA 400, Operating Instruction

Page: 83 / 401

Firmware V3.15 21.04.2021 83/401
6.2.2 Setting of the controller type and master/slave mode
Setting of the controller type
The required controller type can be set via the DIP switch S3 by adjusting the coding switches 1..9 with a thin
screwdriver (D = 2 mm) through a hole in the case cover:
Depending on the now set controller type, the respective functionalities are then displayed or hidden in the
menu of the controller. 8 controller types are available for the definition of the basic controller behaviour, see
chapter
Controller types .
DIP switch S3
Example : Setting of the coding switches for the controller type UA 131 LS.
Caution: data loss! All parameters are reset to their factory settings if the controller type is changed or
due to a first start (see chapter First start / reset controller to factory settings )!

Warning about dangerous electrical voltage!
Danger of electric shock!
The DIP switch S3 may only be adjusted when disconnected from the
power supply . The changes are not applied until the next time the controller is switched on.
