ECKELMANN UA 400, Operating Instruction

Page: 273 / 401

Firmware V3.15 21.04.2021 273/401
•
•
•
•
Menu 2-5-2 Setpoint frame heater
SETPOINTS POS: XXXXX Entry Default
Mod: xxxxxxxxxxxx Displays set frame heater mode (Menu 2-5-1) Fixed on time
Run Time XXX % Fixed on time, Only shown when mode set to
Fixed On Time (Menu 2-5-1) --, 0..100 100 %
emerg.run time XXX % On time in failure of ambient air humidity or
temperature signal (via CAN bus)
Only shown when mode set to Enthalpy Control
(Menu 2-5-1) --, 0..100 100 %
enthalp. offs. XXX % Offset to on time with activated enthalpy control
(via CAN bus)
Only shown when mode set to Enthalpy Control
(Menu 2-5-1) -50..50 0 %
Invert Output xxx Inversion of the function of the frame heater
output (terminal 91/92)
, , (ON/OFF)
ON
Menu 2-5-3 Mode altern.
Select between values. Checkmark shows current setting.
MODE ALT POS: XXXXX Entry Default
fixed run time
Fixed frame heater on time
enthalpy-ctrl rtm Enthalpy control by ambient air temperature and
humidity
Menu 2-5-4 Setpoint altern.
SOLLW. UM POS: XXXXX Entry Default
Mod: xxxxxxxxxxxx Displays set frame heater mode (Menu 2-5-3 Fixed on time
Run Time XXX % Fixed on time, Only shown when mode set to
Fixed On Time (Menu 2-5-3) --, 0..100 100 %
emerg.run time XXX % On time in failure of ambient air humidity or
temperature signal (via CAN bus)
Only shown when mode set to Enthalpy Control
(Menu 2-5-3) --, 0..100 100 %
enthalp. offs. XXX % Offset to on time with activated enthalpy control
(via CAN bus)
Only shown when mode set to Enthalpy Control
(Menu 2-5-3) -50..50 0 %
Menu 2-6 hot gas
HOTGAS POS: XXXXX Entry
1 Zone 1+2 Move to menu 2-6-1 1
2 Zone 1+2 Altern. Move to menu 2-6-2
Not shown when setpoint toggle is disabled (Menu 3-3) 2