Eaton UltraShift PLUS Series, Service Manual

Page: 75 / 263

2018.12.12
© 2017 Eaton. All rights reserved
64
TRSM0940 Service Procedures | VCS/VMS Auxiliary Section Assembly and Installation
4. Install the Range and Deep Reduction Yokes into their
respective sliding clutches on the Auxiliary Mainshaft.
5. On the Deep Reduction Yoke, install the O-ring the will
seat against the piston, P/N 4301348.
6. Lay the Auxiliary Case Housing front on a clean flat
surface. Install the Bearing Race in the Bearing Bore.
7. Position the Auxiliary Case Housing over the Counter-
shaft and Auxiliary Mainshaft Assemblies.
Note: Ensure the inner spacer is installed on the Auxil-
iary Mainshaft.
8 . Install the rear Auxiliary Mainshaft bearing with the
tampered side forward. Use heat or a bearing driver to
fully seat the bearing.
9. Position a new Output Bearing Cover gasket on the rear
Output Bearing Cover mounting surface and install the
Rear Bearing Cover
10. Apply Eaton® sealant #71205 or equivalent to the
retaining cap screws.