![background image](http://html1.mh-extra.com/html/lewitt/stream-4x5/stream-4x5_quick-start-manual_1886933001.webp)
QUICKSTART GUIDE
STREAM 4x5
//
Getting started
Download and install the LEWITT Control Center 2.0
software (
https://lewitt.link/CONTROLCENTER
).
Follow the on-screen installation instructions.
Open the LEWITT Control Center 2.0 software.
Connect your STREAM 4x5 to your computer
via USB cable (bus-powered).
Be careful! Always check output levels before using the
STREAM 4x5 to avoid damage to your ears.
//
I/O Section
USB connection (bus powered) – Connect
your STREAM 4x5 to your computer
Input for external 5V power supply (optional)
Smart I/O – 3.5mm TRRS jack for bidirectional
audio transmission
1x 3.5mm stereo jack output – Connect your speakers
2x 6.3mm balanced audio jack – Connect your studio
monitor speakers.
PLEASE NOTE:
Both speaker outputs are using the same
signal. They always have identical output signal
and level.
2x Mic/Line XLR/Instrument combo jack – Connect
your microphone or instrument
1x 6.3mm headphone jack (front)
//
User Interface
Input 1
Input 2
Clipping LED – Green = Signal ok, Orange = Low headroom,
Red = Signal is clipping
Speaker output
Headphone output
Smartphone output
Top bar graph
Bottom bar graph
Jog dial
//
Jog Dial Operation
Push the jog dial to cycle through all available settings.
Rotate the jog dial to change the selected value
(e.g. set gain, output volume, etc.).
Idle State – after 5 seconds of inactivity, the bar graphs switch
to an idle state, showing input or output metering depending
on the last setting you were making.
Figure 2 – I/O Section in the front of the interface
Figure 3 – User interface
Figure 4 – Jog dial
Figure 1 – I/O Section in the back of the interface
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
16
1
2
3
4
5
6
7
10
8
11 13
14
10
9
12
15