Below are steps to install, configure and test the H-531, H-831 and M-560
Telex USB Microphones.
These steps were written for
Windows 98, and Windows 98 Second Edition
.
The steps are the same for both editions. Depending on your computer, the
installation may or may not go through all of the installation steps. Your
computer may go through many of the steps without prompting you. Be sure to
follow this manual carefully to confirm that you have successfully installed the
device.
The H-531, H-831and the M-560 install the same way. Two device drivers will be
loaded, the USB Composite Device and the USB Audio Device. The USB Audio
Device may also appear as the Telex USB Microphone. The drivers for the USB
Composite and USB Audio Device/USB Microphone are found in the Windows
operating system.
Note
: You do not need an installation disk for either
microphone.
NOTE: The H-531 is a headworn microphone, not a headset. There is no
speaker in the earpiece
.
The foam cushion is for comfort only.
1. Installation
a. Plug the microphone directly into an USB port on your computer.
b. The
Add New Hardware
wizard will detect the USB Composite Device.
To begin installing the USB Composite Device, click
Next.
c. Select the option to let Windows
Search for the Best Available Drivers
and click
Next.
d. Select the option to
Specify a Location
and type in
c:\windows
in the
pathway and click
Next.
e. Windows should find the driver and install it. Click
Next
to install the
driver.
Note
: the location of the driver is
c:\windows\inf\usb.inf.
f. After Windows has completed installing the USB Composite Device, click
Finish.
After the USB Composite Device has been installed, the computer will start to
install the USB Audio Device.
Note
: the USB Audio Device may also appear as
the Telex USB Microphone
g.
The
Add New Hardware
wizard will start up again and look for the USB
Audio Device, click
Next.
