Easy xLogic, User Manual

Page: 78 / 226

76 76 76 76
The INV input can be used to invert the output signal. The input block INV only inverts the
output signal if the block is enabled via EN.
If retentivity is not set, output Q and the expired time are reset after a power failure.
4 4 4 4.4.8 .4.8 .4.8 .4.8 Random Random Random Random generator generator generator generator
Short Short Short Short description description description description
The output of a random generator is toggled within a configurable time.
Connection Connection Connection Connection Description Description Description Description
Input En En En En The positive edge (0 to 1 transition) at the enable input En
(Enable) triggers the on delay for the random generator.
The negative edge (1 to 0 transition) triggers the off delay
for the random generator.
Parameter TH:
TH: TH:
TH: The on delay is determined at random and lies
between 0 s and T
H
.
TL: TL: TL: TL: The off delay is determined at random and lies
between 0 s and T
L
.
Output Q Q Q Q Q is set on expiration of the on delay if En is still set. It is
reset when the off delay time has expired and if En has not
been set again.
Parameter Parameter Parameter Parameter
The on-delay time TH and the off-delay time TL can be provided by the actual value of another
already-programmed function:
Analog comparator: Ax – Ay
Analog trigger: Ax
Analog amplifier: Ax
Analog multiplexer: AQ
Analog ramp: AQ
Analog math: AQ
PI controller:AQ
Data latching relay: AQ
Up/Down counter: Cnt
The value of
＂ＴＨ＂，＂ＴＬ＂
can be set/modified in parameter mode. For information about
how to modify, refer to chapter 5.2.2 please.
Timing Timing Timing Timing diagram diagram diagram diagram