Easy xLogic, User Manual, Page: 166 / 226

164 164 164 164
If xLogic has several alarm interfaces in the same period and it only displays the message with
highest priority in the block, also you may go through all alarm messages by pressing or
key.
Note: Note: Note: Note:
The message text block would be treated as parameter page only when it has no input,
otherwise, it may be regarded as alarm page. When input has high pulse, LCD shall display
alarm message.
5
5 5
5.2
.2 .2
.2 Select
Select Select
Select function
function function
function page
page page
page
Press ESC key to change from running mode to function page.
After pressing ESC key, xLogic would be switched to function page and meanwhile open
function menu as figure below shows.
Brief
Brief Brief
Brief introduction
introduction introduction
introduction on
on on
on four
four four
four options
options options
options of
of of
of function
function function
function page:
page: page:
page:
� � � � Run/stop Run/stop Run/stop Run/stop
Select this menu to switch over xLogic status between RUN and Stop. Refer to chapter5.2.1 for
details.
�
� �
�
Set Set Set Set Param Param Param Param
To set function block parameter. Refer to chapter 5.2.2 for details.
�
�
� � Set Set Set Set… … … …
Used to set /modify password and set address of expansion module, refer to chapter 5.2.3 and
5.2.4 for details please.