Easy xLogic, User Manual, Page: 20 / 226

18 18 18 18
C
C
C Chapter
hapter
hapter hapter 2
2
2 2 Installing/removing
Installing/removing
Installing/removing Installing/removing xLogic
xLogic
xLogic xLogic
Dimensions
Dimensions Dimensions
Dimensions
The xLogic installation dimensions are compliant with DIN 43880.
xLogic can be snap-mounted to 35 mm DIN rails to EN 50022 or on the wall.
xLogic width:
� ELC-12 Series Main Module has a width of 72mm.
� ELC12-E expansion mddule have a width of 48mm
� ELC-18 Series Main Module has a width of 95mm.
�
� �
�
ELC-E expansion modules have a width of 72mm .
Note Note Note Note
The figure below shows you an example of the installation and removal of an ELC-12 CPU and
one expansion module ELC-12 CPU. The measures shown apply to all other ELC-12 Series
versions and ELC-18 Series versions and expansion modules.
W a r n i n g
W a r n i n g W a r n i n g
W a r n i n g
Always switch off power before you “remove” and “insert” an expansion module.
2.1 2.1 2.1 2.1.1 .1 .1 .1 DIN DIN DIN DIN rail rail rail rail mounting mounting mounting mounting
Mounting Mounting Mounting Mounting
How to mount a xLogic Basic module and a expansion module onto a DIN rail:
1. Hook the xLogic Basic module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
3. Hook the xLogic expansion module onto the rail
4. Slide the digital module towards the left until it contacts the xLogic Basic.
5. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
6. Take the plastic cover in the expansion port of CPU and expansion module.
7. Plus the connection bridge