Easy xLogic, User Manual, Page: 68 / 226

66 66 66 66
4 4 4 4.4.1 .4.1 .4.1 .4.1 On-delay On-delay On-delay On-delay
Short Short Short Short description description description description
The output is not switched on until a configured delay time has expired.
Connection
Connection Connection
Connection Description
Description Description
Description
Trg
Trg
Trg Trg input The on delay time is triggered via the Trg (Trigger) input
Parameter T T T T represents the on delay time after which the output is
switched on (output signal transition 0 to 1).
Retentivity
Retentivity Retentivity
Retentivity on = the status is retentive in memory.
Output Q
Q
Q Q Q switches on after a specified time T has expired, provided Trg
is still set.
Parameter
Parameter Parameter
Parameter T
T T
T
The time for parameter T can also be preset based on the actual value of another, already-configured
function. You can use the actual values of the following functions:
Analog comparator: Ax - Ay
Analog trigger: Ax
Analog amplifier: Ax
Analog multiplexer: AQ
Analog ramp: AQ
Analog math: AQ
PI controller:AQ
Data latching relay: AQ
Up/Down counter: Cnt
You select the required function via the block number. Time-base can be adjusted.
The value of
＂
T
＂
can be set/modified in parameter mode. For information about how to
modify
，
refer to chapter 5.2.2 please.
For information on the validity and accuracy of the time base, refer to the xLogic time-base list
as follows:
Valid Valid Valid Valid ranges ranges ranges ranges of of of of the the the the time-base, time-base, time-base, time-base, if if if if T T T T = = = = parameter parameter parameter parameter
Time-base Time-base Time-base Time-base Max. Max. Max. Max.
value
value value
value
Min. Min. Min. Min. resolution resolution resolution resolution Accuracy Accuracy Accuracy Accuracy
s (seconds) 99:99 10 ms ± ± ± ± 10 ms
m (minutes) 99:59 1s ± 1 s
h (hours) 99:59 1 min ± 1 min