Dynapac CP275, Instruction Manual

Page: 41 / 115

Operation
33
4812273203.pdf
2017-08-25
Driver seat - Adjustment
Operation
Before starting
Master switch – Switching on
Remember to carry out daily maintenance. Refer
to the maintenance instructions.
The battery disconnector is located in the engine
compartment, on the right side of engine parts.
Open the engine hood, turn the key (1) to the On
position. The roller is now supplied with power.
If the main battery/master switch is
covered, the engine hood must be unlocked
driving operation, to be able to reach the
switch in an emergency.
Do not run the starter motor for too
long(max. 30 seconds). If the engine will not
start, wait two minutes before trying again.
Adjust the operator’s seat so that the position is
comfortable and so that the controls are within
easy reach.
The seat can be adjusted as follows.
- Length adjustment (1).
- Back support angle (2).
Always make sure that the seat is
secure before beginning operation.
1
Fig1. Engine compartment
1. Battery disconnector
1
2
Fig2. Driver seat
1. Locking lever – Length
adjustment
2. Backrest angle