Dynapac CP275, Instruction Manual

Page: 104 / 115

Maintenance – 2000h
96
4812273203.pdf
2017-08-25
Fig. Hydraulic reservoir
drain plug
Hydraulic reservoir - Fluid change
Take great care when draining the
hydraulic fluid. Wear protective gloves and
goggles.
Hydraulic reservoir’s drain plug is located on the left
front side of the frame, under the hydraulic reservoir.
Open the drain plug to run out oil inside the hydraulic
reservoir.
Place a receptacle that holds at least 80 liters (21 gal)
under the engine compartment.
Remove the plug on the end of the hose.
Allow all the oil to run out. Reset by refitting the drain
plug.
Deliver the drain oil to environmentally
correct handling.
Fill with fresh hydraulic fluid. Refer to the lubricants
specification for grade information.
Replace the hydraulic filter. See section "Maintenance
– 1000 hours”.
Start the engine and operate the hydraulic functions.
Check the level in the reservoir and top off as required.