Dynapac CP275, Instruction Manual

Page: 112 / 115

Additional instruction
104
4812273203.pdf
2017-08-25
Fig 6
Fig 7
Fig 8
Fig 9
- Tighten the lock nut. Fig 6.
Close the gas valve.
Loosen the lock nut of the air valve using a wrench,
screw out the valve element about 10mm with a screw
driver, and tighten the lock nut.
Air charge and discharge
Air charge or discharge is control by the toggle switch
on instrument panel; Push up is air charging and push
down is air discharging, The neutral position is off.
Fig 7, Fig 8
Before operating the system, make sure the air
pressure is normal and all the air valves are opened.
Usually keep the nine tire’s pressure as the same
about 600kPa, it will get the better compaction
performance.
Maintenance - Air on the run (Optional)
Every day / 10 hours
Check the air pressure from the air gauge on
instrument panel, it should be in 380kPa~780kPa.
Every week / 50 hours
Water drain of air tank; Fig 9.
Caution: In the case of the temperature is low, the
water drain valve may be damaged by the water iced!
Please drain the water more often.