DynaGen Tough Series, User Manual

Page: 33 / 66

Settings 32
© 2019 DynaGen Technologies Inc
TOUGH Series Manual
Name Active Mode Description
Pull Coil Cranking See Pull and Hold Coil section for more information.
LCD Backlight Global Active when LCD Backlight is active.
Voltage Regulator Running Active when engine is starting/running and is not in Idle Mode.
ETS (Energize to Stop) ETS Timer Active during Energize to Stop timer. See ETS On Duration under Timers >
Engine Logic for more details.
Off Mode (Not In Auto) Off Active when the controller is in the OFF mode.
Idle Mode Idle Mode Active when the controller is in IDLE mode. For example when the idle
switched input is active or during warmup and cooldown if warmup idle and
cooldown idle settings under Timers > Engine Logic are enabled.
Battle Mode Battle Mode Active when Battle Mode switched input is active.
System OK (System
Ready) Auto, Run Active when the controller is in the AUTO and RUN mode and no warnings
or failures are present.
Delay to Start Delay to Start Timer Active when the Delay to Start timer is active.
Glowplug Preheat, Midheat,
Postheat Active during the Preheat, Midheat and Postheat timers.
Warmup Warmup Timer Active in RUN mode after Warmup timer has expired. Is not active in the
cooling down state or other states. Typically used to apply load to engine
only after it has warmed up and to remove the load on cooldown.
Cooldown Cooldown Timer Active when Cooldown timer is active.
Engine Running Running Active after crank success.
Exercising Exercise Timer Active during the engine exercising cycle.
Batt. Recharge (Battery
Recharge) Battery Recharge
Timer Active during the battery recharge cycle.
Maintenance
(Maintenance Required) Global Active when Maintenance timer has expired. If the timer has expired when
the controller is in the RUN mode the output does not turn on until the
controller enters the OFF or AUTO mode. See the
Maintenance section.
LowBat InCrank (Low
Battery During Cranking) Cranking Active when Low Battery During Cranking warning is displayed.
Aux Sensor 1
Auxiliary Settings
Dependent
Active dependent upon settings in the Auxiliary sensor section.
Aux Sensor 2
Aux Sensor 3
Aux Sensor 4
Force Regen User Controlled When user triggers a Force Regeneration, output is active for 20 seconds
then switches off.
Regen Inhibit User Controlled When user triggers a Regeneration Inhibit, output is active for 20 seconds
then switches off.
Common Failure Any Failure Active when any failure occurs.
RPM Increment Running Output is used to to trigger inputs on an ECM to control speed. See Front
Panel Speed Control section for more information.
RPM Decrement Running Output is used to to trigger inputs on an ECM to control speed. See Front
Panel Speed Control section for more information.
DEF Fluid Pump Running Active when DEF Fluid Level falls below the DEF Low Level and stays
active until the level rises above the DEF High Level. See
CAN Bus
(J1939) section for more information.
Genset Disable Global Disables the generator during a stationary Regen on Kubota engines (see
Aftertreatment in the J1939 User Manual ) or also during an engine IDLE
condition from the IDLE switched input. Automatic idle is ignored. If the
generator voltage is not below the under voltage setpoint in 10s, the
controller will shut down the engine on "Generator Disable Failure."
Dummy Load Running Output is controlled by the dummy load feature.