DynaGen Tough Series, User Manual

Page: 7 / 66

Installation 6
© 2019 DynaGen Technologies Inc
TOUGH Series Manual
2 Installation
Generator systems contain high voltage circuitry and precautions to protect against electrical shock should be taken. Failing to
power down and lock out equipment can cause damage, injury or death.
WARNING : Wiring of this controller should be performed by qualified electricians only.
The following general electrical safety precaution should be followed:
·
Do a thorough inspection of the area before performing any maintenance.
·
Keep fluids away from electrical equipment.
·
Unplug connectors by pulling on the plug and not the cord.
·
Use fuses where appropriate.
·
Ensure all equipment is properly grounded.
·
Provide support to wires to prevent stress on terminals.
To ensure proper and safe operation, caution must be taken at the installation site to make sure it is free from excessive
moisture, fluctuating temperature, dust and corrosive materials. Choose a mounting surface with the least amount of vibration
and not more than
0.125" (3.175mm) thick.
1) Choose a suitable mounting location based on the criteria above.
2) Create a rectangular cutout in the panel that is minimum 3.9" (99mm) high and 6.2" (158mm) wide.
3) Place the controller into the panel cutout so that the LCD screen and buttons are facing out.
4) Place the mounting clips into the designated slots on the top and bottom of the controller.
5) Tighten the screws on the clips until the controller is snug against the panel. Do not over tighten, the bottom of the
screws should angle very slightly away from the controller.
6) If applicable, snap the RelayPak (RP100) to the back of the controller. Place one side of the RP100's tabs into the slot
on the back of the controller and, without pushing on the relays, snap the other tab into place.
TE Series Cutout (Not To Scale)