DynaGen Tough Series, User Manual

Page: 65 / 66

Settings 64
© 2019 DynaGen Technologies Inc
TOUGH Series Manual
gain for the same size error. This value must be tuned for each
installation.
Setpoints > Main-In
(Maintain In Setpoint) 1 ~ 900 in 0.1
increments
300.0
The level set-point to attempt to maintain. Only applies if System is set
to In-Keep. This value takes on the units of the Aux sensor set in the
Closed Loop > Sensor In menu.
Setpoints > Main-Out
(Maintain Out
Setpoint) 1 ~ 900 in 0.1
increments
500.0
The level set-point to attempt to maintain. Only applies if System is set
to Out-Keep. This value takes on the units of the Aux sensor set in the
Closed Loop > Sensor In menu.
Setpoints >
D (High
Deadband) 1 ~ 30 in 0.1
increments
3.0
The high limit of the dead-band.
Setpoints >
Deadband- (Low
Deadband) 1 ~ 30 in 0.1
increments
3.0
The low limit of the dead-band.
Thresholds > High
Edge (High Limit) 1 ~ 900, 0.1
increments
700.0
The high saturation. The maximum level at which the RPM control is
fixed. This value takes on the units of the Aux sensor set in the Closed
Loop > Sensor In menu.
Thresholds > Low
Edge (Low Limit) 1 ~ 900, 0.1
increments
100.0
The low saturation. The minimum level at which the RPM control is
fixed. This value takes on the units of the Aux sensor set in the Closed
Loop > Sensor In menu.
Thresholds > Max
RPM (Max Limit
RPM) 500 ~ 4000 RPM
in 1 RPM
increments
3200
RPM
The fixed RPM that should be used when the level rises above the High
Edge.
Thresholds > Min
RPM (Low Limit
RPM) 500 ~ 4000 RPM
in 1 RPM
increments
1000
RPM
The fixed RPM that should be used when the level falls below the Low
Edge.