dynabook PORTEGE X30W-J, Maintenance Manual

Page: 187 / 282

4.11 HEAT SINK 4 Replacement Procedures
PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941) [CONFIDENTIAL] 4-45
Installing the HEAT SINK
To install the HEAT SINK, follow the steps below and refer to Figure 4-15.
1. When silicon grease is already applied to the CPU or HEAT SINK, wipe them off
with a cloth in advance.
2. Apply new silicon grease (Shin-Etsu Chemical Co. X-23-7921-5) on the CPU using a
special syringe.
NOTE : Apply new silicon grease as shown in the figure below.
3. Set the HEAT SINK in place and secure it with the following screws .

M2

2.3C S-THIN HEAD screw

4
NOTE: When securing the HEAT SINK, be sure to secure the screws in the order of the
number marked on the HEAT SINK.
Silicon grease
Silicon grease