3 Tests and Diagnostics
PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941) [CONFIDENTIAL]
3-5
NOTE:
1. Connect the AC adapter to the computer when you update the BIOS,
EC/KBC or ME FW.
2. Do not turn off the power while you are updating the BIOS or EC/KBC.
If the update fails, it might be impossible to start up the computer.
3. If the update rewrite fails, when you next turn on the power, the power LED
may flash or a message may be displayed. In that case, turn on the power
again and perform Procedure 3 or 4.
The following message will appear. If the PCB exchange or MDI information rewrite has
been done, press
Y
. Otherwise, press
N
.
Change
PCB ? or After Update DMI ? (y/n)
After that, the following test program menu (Top Menu) is displayed. (The menu below
shows an example of screen.)
Select Menu ( [Num] or [
↑
][
↓
] --–> [Enter]
To start the DMI Entry Utility, press
1
and
Enter
.
To start the Heatrun Test, press
2
and
Enter
.
To start the Main Test Menu, press
3
and
Enter
.
NOTE:
Before starting the diagnostics, be sure to that all the cables are connected
firmly.
Summary of Contents for PORTEGE X30W-J
Page 11: ...Chapter 1 Hardware Overview...
Page 39: ...Chapter 2 Troubleshooting Procedures...
Page 139: ...Chapter 4 Replacement Procedures...
Page 229: ...CONFIDENTIAL Appendices...
