Du Pont Cyrel FAST 2000TD, Operation Manual

Page: 65 / 106

Maintenance
4-7
Change of supply and waste rolls
Changing nonwoven (NW) and PET rolls
Follow the description below when changing nonwoven or PET rolls. For change of waste rolls please refer
to the "Changing the waste roll" on page 4-15.
WARNING: Refer to the "Safety precautions" on page 0-9 and the separate Safety Instruction
Manual part No 21741 .
WARNING: Wear safety protection, e.g. safety shoes, when handling the heavy rolls.
WARNING: It is strongly recommended that when the nonwoven is changed for a new roll, the
waste roll should always be removed regardless of how full it is, and an empty core fitted (see
section about changing the waste roll).
Tools required
• Translyft or other lifting device. Please see detailed description of operating the "Translyft lift table" on
page 2-17.
NOTE: The lifting device is an optional extra.
• Pair of scissors or stanley knife.
• Double-side self-adhesive heat resistant tape (e.g. Tesa 4965 (50 mm/2"), heat resistant up to 200 °C
transient/100 °C prolonged).
• Duct tape.
Procedure
1. Open the rear cover.
2. Dismount the air compression hose for the
air shaft on the right side of the roll: pull the
lock ring of the quick release coupling
upwards to release the air pressure.
Release the lock ring, then lift the entire
coupling upwards to remove.
January, 2020 Operation Manual | Cyrel FAST 2000TD