Du Pont Cyrel FAST 2000TD, Operation Manual

Page: 31 / 106

Operation procedures
2-13
Manual eject function (after completed processing)
The plate will continue to rotate around the static drum after processing is complete. Follow the procedure
below to release the plate from both the front and rear clamp arm.
Manual procedure
The control panel will now display the blue 'Eject'
button.
Press the 'Eject' button once (this will eject the
front edge of the plate) and hold onto the plate as
the next operation will release the plate completely
from the processor. If it is not held, it will fall onto
the floor.
Once the plate has been fully ejected from the
processor, both clamp arms will automatically
return to their respective load positions ready for
the next plate.
Manual eject function (interrupting processing)
If the plate has to be manually ejected after loading, this can be done at any point through the program until
the automatic ejection procedure starts.
The reason for manual ejection could be:
• Incorrect plate parameters have been entered into 'Job selection'. When realizing this, the plate must
be ejected to avoid potential damage to the plate and/or the processor.
• A visual check through the window in the top cover reveals that the plate has not been loaded
correctly and thus must be ejected.
• A visual check through the window in the top cover reveals that part of the plate is not correctly
attached to the front or rear clamp arm pins. The plate must be ejected to avoid further damage of the
plate.
• Other reasons for need of manual ejection could be; emergency stop has been activated, top, front, or
rear covers have been opened during processing, or an alarm which requires ejection/removal of the
plate.
Procedure (operator interrupted)
1. Select the red 'Stop' button on the control
panel.
January, 2020 Operation Manual | Cyrel FAST 2000TD