Du Pont Cyrel FAST 2000TD, Operation Manual

Page: 25 / 106

Operation procedures
2-7
Selecting a job
The processing software offers the operator to choose from preset programs for easy job selection. Job
selection is described in the following.
When the processor has been started and
initialized, and the processor is ready for
processing, the control panel home view will
prompt the operator to select the plate width.
NOTE: If not switching between plate
types, and if processing has not been
interrupted, you need only select the plate
width.
If in doubt, check whether the other job selection
fields match the plate type you want to process.
See below.
NOTE: The label on the plate package lists
all the information needed for the job
selection.
First Cycle (1):
A processing job consists of several processing
cycles. Normally all processing jobs will start from
cycle number 1.
Exception: If a plate has been ejected before all
the programed cycles have been completed, and
you wish to finish the processing cycle, you can
enter the cycle number from which you want to
resume the process. Normally you should enter
the cycle number that was about to start, when the
plate was ejected. Then re-insert the plate and
press the 'Start' button in order to complete
processing of the plate.
Allowed values: min. 1 - max. 18 (depending on
program)
When a processing job has been completed the
'First cycle' will automatically return to '1'.
January, 2020 Operation Manual | Cyrel FAST 2000TD