Du Pont Cyrel FAST 2000TD, Operation Manual

Page: 23 / 106

Operation procedures
2-5
Preparing the processor for plate load
Processor initialization
The processor has to be correctly initialized and ready to accept a plate. When ready for plate load, the
home view will display "Please select plate width" and the stack light will turn green.
If the stack light is not green, check the warnings and errors displayed in the home view or the alarm list.
Web status
Check the status of nonwoven (NW), PET, and waste before loading a plate. See detailed description of
"Status of nonwoven (NW), PET and Waste" on page 3-2.
Plate Preparation
Ensure the plate is in a good condition and ready for processing.
CAUTION: The plate should have straight, square cut edges without damage and the plate surface
and Mylar back side must be free from any damage, dirt or debris.
CAUTION: This processor is built for single plate load only. Do not try to load two parallel plates.
Select a Job
Make settings according to the description "Selecting a job" on page 2-7.
CAUTION: It is very important to make correct job selection for the plate type in use. If e.g. plate
gauge does not apply to the actual plate, it could result in damage of the plate and potential damage
to the processor.
January, 2020 Operation Manual | Cyrel FAST 2000TD