DSE 8610 MKII, Operator'S Manual

Page: 87 / 188

Description of Controls
Page 87 of 188 057-254 ISSUE: 2
NOTE: For further details, see section entitled Operation elsewhere in this manual.
Icon Description
Alarm Mute / Lamp Test
This button silences the audible alarm in the controller, de-activates the Audible
Alarm output (if configured) and illuminates all of the LEDs on the module’s facia
as a lamp test function.
Start
This button is only active in the Stop/Reset Mode , Manual Mode
Pressing the Start button in Stop/Reset Mode powers up the engine’s
ECU but does not start the engine. This can be used to check the status of the
CAN communication and to prime the fuel system.
Pressing the Start button in Manual Mode starts the generator and runs it
off load in Manual Mode
Menu Navigation
Used for navigating the instrumentation, event log and configuration screens.
Close Generator
The Close Generator button controls the operation of the generator load
switch and is only active in the Manual Mode once the generator is available.
Pressing the Close Generator button when the generator is available and off
load automatically instructs the generator to synchronise and once in sync, to be
place the generator on load (‘Close Generator Output’ becomes active). If the
generator bus is dead (has not supply on it) the generator is placed on load
immediately. Further presses of the Close Generator button have no effect.
Open Generator
The Open Generator button is only active in the Manual Mode and
allows the operator to open the generator load switch.
Pressing the Open Generator button when the Generator is on load,
automatically ramps the load off the generator and then takes it off load (‘Close
Generator Output’ becomes inactive). Further presses of the
Open Generator button have no effect.