DSE 8610 MKII, Operator'S Manual

Page: 12 / 188

Introduction
057-254 ISSUE: 2 Page 12 of 188
1.3.3 TRAINING GUIDES
Training guides are provided as ‘hand-out’ sheets on specific subjects during training sessions and
contain specific information regarding to that subject.
DSE Part Description
056-001 Four Steps To Synchronising
056-005 Using CTs With DSE Products
056-006 Introduction to Comms
056-010 Over Current Protection
056-011 MSC Link
056-013 Load Demand Scheme
056-018 Negative Phase Sequence
056-019 Earth Fault Protection
056-020 Loss Of Excitation
056-021 Mains Decoupling
056-022 Breaker Control
056-023 Adding New CAN Files
056-024 GSM Modem
056-026 kW, kvar, kVA and pf.
056-029 Smoke Limiting
056-030 Module PIN Codes
056-033 Synchronising Requirements
056-036 Expansion Modules
056-043 Sync Process
056-045 PLC as Load Demand Controller
056-047 Out of Sync and Failed To Close
056-051 Sending DSEGencom Control Keys
056-053 Recommended Modems
056-054 DSE xx10 In Fixed Export
056-055 Alternate Configurations
056/057 SW1 & SW2
056-069 Firmware Update
056-071 DSE8610 Auto Test Manual
056-072 Dead Bus Synchronising
056-075 Adding Language Files
056-076 Reading DSEGencom Alarms
056-079 Reading DSEGencom Status
056-080 MODBUS
056-081 Screen Heaters
056-082 Override Gencomm PLC Example
056-083 Synchronising & Loadsharing
056-086 G59
1.3.4 THIRD PARTY DOCUMENTS
The following third party documents are also referred to:
Reference Description
ISBN 1-55937-879-4
IEEE Std C37.2-1996 IEEE Standard Electrical Power System Device
Function Numbers and Contact Designations. Institute of Electrical and
Electronics Engineers Inc
ISBN 0-7506-1147-2 Diesel generator handbook. L.L.J. Mahon
ISBN 0-9625949-3-8 On-Site Power Generation. EGSA Education Committee.