Doran 2200 Series, Instruction Manual

Page: 24 / 136

23
NOTE: If a Password number has been stored, the password protection will be activated
upon power up.
To enable password protection, press and hold the ENTER button for 2 seconds to
activate the password protection.
Barcode Entry to recall Product ID Field (2200CW, 250 product setting)
There are two ways to recall a Product ID Field from the scale’s memory. Up to 6
numeric characters can be read into the 2200CW barcode serial port to request an
existing Product ID.
1. Press PROD ID to enter the Product ID recall mode. The display will show
Id
,
followed by the current Product ID number. Using Doran’s optional barcode scanner,
scan the desired barcode. The display will confirm by showing the barcode value. To
exit the ID edit mode, press ID.
2. When the scale is in the normal weighing operation, use Doran’s optional barcode
scanner to scan in a barcode value that begins with a numeric character. The
barcode value does not require a serial command to recall a saved Product ID field.
Display Product ID Values (2200 series, one product setting)
Press PROD ID to enter the Product ID recall mode. The last viewed or edited ID will be
displayed. The display will show
prd Id
, followed by the current IDs value. Press
UNITS or PRINT to scroll through the eight available IDs. The annunciators below the
main display indicate which ID is currently displayed. Press CLEAR to exit this mode,
the display will read
abort
to indicate no changes were made to the values.
The ID displayed is the last edited or displayed ID.
Keypad Entry of Product ID Values (2200 series, one product setting)
Press PROD ID to enter the ID edit mode. The last viewed or edited ID will be
displayed. The display will show
prd Id
, followed by the current IDs value. Press
UNITS or PRINT to scroll to the desired ID. The annunciators below the main display
indicate which ID is currently displayed.
Enter up to six digits through the numeric keypad. Press ENTER to accept the change
and return to the weigh mode or press UNITS or PRINT to save and edit other IDs. To
exit the ID edit mode press ID.
The display will read
abort
to indicate no changes were made to the stored values or
the display will read
SaVed
to indicate the value is saved.