Doran 2200 Series, Instruction Manual

Page: 19 / 136

18
Change Preact Values
Press and hold the SET POINT button for three seconds to enter the preact edit mode.
The last viewed or edited preact will be displayed. Press UNITS or PRINT to scroll
through the eight available preacts. The annunciators below the main display indicate
the current preact.
To change the preact value, enter the preact value using the numeric keypad. Press
ENTER to accept the change and return to the weigh mode or press UNITS or PRINT to
save and edit other preacts. Press SET POINT to exit this mode.
The display will read
abort
to indicate no changes were made to the preact values, or
the display will read
Saved
to indicate the preact value is saved.
Barcode Entry of Preact Values
Press and hold the SET POINT button for three seconds to enter the preact edit mode.
The display will momentarily show
PrEACt
, then flash the current preact weight. Press
UNITS or PRINT to scroll through the eight available preacts. The annunciators below
the main display indicate the current preact.
Using Doran’s optional barcode scanner, scan the desired barcode. The display will
read
SAVEd
to indicate the scanned preact weight is saved. The display will flash the
new preact weight scanned from the barcode. No special serial commands are needed
prior to the weight data in barcode value. The barcode value must not exceed the
indicator's count by resolution and cannot be greater than the capacity. The barcode
value can be read into each of the eight available preacts. To exit the preact edit mode,
press the SET POINT button.
Over, Under and Accept Checkweighing Operation (2200CW)
1. Remove all items from the scale platter.
2. Press ZERO to zero the scale. The weight indication should now be zero.
3. Place an item on the scale platter and wait for the motion (MOT) to turn off,
indicating a stable weight.
4. If the item is heavier than the over limit, the OVER indicator will light. If the item is
lighter than the under limit, the UNDER indicator will light. If the weight is between
the limits, the ACCEPT indicator will light.
Five Band Checkweighing Operation (2200CW optional configuration)
1. Remove all items from the scale platter.
2. Press ZERO to zero the scale. The weight display should now be zero.
3. Place an item on the scale platter and wait for the motion (MOT) annunciator to turn
off, indicating a stable weight.
4. If the item is heavier than the high limit, the OVER indicator will flash. If the item is
heavier than the “over” limit but lighter than the “high” limit, the OVER indicator will