Putting the device into operation
98
Access Manager Compact & HiSec, Access Manager Terminal Compact &
HiSec and Access Manager ITT:
The lower LED of ELS and all four LEDs of ENiQ emit one long yellow flash
and two long green flashes. The upper LED then lights up red permanently.
If the upper LED of ELS and four LEDs of ENiQ emit one long yellow
flash and two long red flashes and then light up red permanently after
the power supply has been established, either the date and time are
incorrect or an error has been detected.
Connected passive readers:
The lower LED of ELS and all four LEDs of ENiQ emit one long yellow flash
and two long green flashes. The upper LED then lights up red permanently.
Connected external reader of the ENiQ Module Reader/Module Reader
Terminal:
The status LED flashes every second as long as no connection to the Access
Manager is made or the Access Manager is re-initialised.
Proceed as follows to initialise the device:
Hold the master card directly in front of the control unit, approx. 1 cm away
from it.
Access Manager Compact & HiSec, Access Manager Terminal Compact &
HiSec and Access Manager ITT:
All LEDs flash in the following sequence during the initialisation process:
one long yellow flash
one short red flash
one short green flash
one short yellow flash
one short blue flash
one long yellow flash
After this, the device goes through all possible colours once. This can take up
to ten seconds and after this the device restarts.
