Assembling the device
36
The following device illustrations are schematic diagrams. Details of the
devices can deviate from these.
Installation of the mounting frame on the wall with surface-mounting frame
Proceed as follows to install the
device:
First lay the necessary
connecting cables.
Observe and follow the generally
applicable VDE regulations when
doing so.
Mark the position of the four
holes on the wall.
Drill the marked holes with a
4 mm bit.
Insert the plugs into the drill
holes.
Initially attach the surface-
mounting frame loosely with the
washers and the four screws (3 x
25) included in the scope of
supply.
Align the surface-mounting frame
so that the top edge of the
housing is horizontal.
Tighten the screws so they are
hand-tight.
The installation position of the mounting frame is marked by an arrow on
the mounting frame. The arrow must point upwards.
Guide the connection cables
through the mounting frame.
Place the mounting frame on the
surface-mounting frame.
Initially attach the mounting
frame loosely to the surface-
mounting frame with the two
screws
(3 x 12) included in the scope of
supply.
