Programming a device
108
Programming a device
The following description applies to all ENiQ and ELS devices.
Programming with the master or programming card is always carried out on
the Access Manager/-Terminal/-ITT, i.e. on the control unit. Signalling on any
passive readers which are connected only indicates that the control unit is
busy. The upper LED on the passive readers lights up red again permanently
once the programming process is complete. With the ENiQ Module Reader,
the status LED goes out and lights up again once the process is complete.
Creating locking or programming media offline without software
You require the master card or programming card and the media (e.g.
transponder) that you want to create. The media must always be created on
the control unit. It is not possible to create them on the external reader of the
ENiQ Module Reader. Please bear this in mind for your installation position so
that the control unit is not rendered inaccessible.
You can create a maximum of one master card, five programming cards
and 5,000 locking media (for ENiQ devices) or 3,000 locking media (for
ELS devices). If you have created a programming card, you can also
carry out further programming with this programming card.
ELS devices
Proceed as follows to create locking or programming media offline without
software:
Hold the master card directly in front of the DOM device, approx. 1 cm away
from it (control unit for HiSec).
Remove the master card once again.
The lower LED briefly flashes green twice. You will hear an audible signal
each time.
Hold the programming media or locking media to be created directly in front
of the control unit in turn and wait briefly for signalling.
The lower LED briefly flashes green once. You will hear an audible signal
each time.
To end the programming process wait for around five seconds or hold the
master card directly in front of the control unit.
The lower LED issues one short green flash and one long green flash and you
will hear an audible signal each time.
Now, you can create or delete locking media with the authorised programming
card and activate the device with the authorised locking media.
